Hyundai Tucson (NX4) 2022-2026 Service Manual / Engine Mechanical System
Hyundai Tucson: Engine Mechanical System
- Specifications
- Special Service Tools
- Repair procedures
- Troubleshooting
- Engine And Transaxle Assembly
- Drive Belt System
- Timing System
- Cylinder Head Assembly
- Cylinder Block
- Components and Components Location
- Water Jacket Insert
- Drive Plate
- Rear Oil Seal
- Piston and Connecting Rod
- Crankshaft
- Cylinder Block
- Cooling System
- Coolant
- Radiator
- Cooling Fan
- Reservoir Tank
- Integrated Thermal Management Module (ITM)
- Water pump
- Active Air Flap
- Lubrication System
- Components and Components Location
- Flow Diagram
- Engine Oil
- Oil Filter & Oil Cooler
- Oil Pan
- Oil Pressure Switch
- Oil Pump
- Balance Shaft Module
- Oil Level Gauge & Pipe
- Oil Pressure Control Solenoid Valve
- Oil Level Sensor
- Intake And Exhaust System
Specifications
- Specifications
DescriptionSpecificationsLimit
General
TypeIn-line, DOHC　
Number of cylinders4　
Bore88.5 mm (3.484 in.)　
Stroke101.5 mm (3.996 in.)　
Total displacement2497 cc (152.38 ...
Other information:
Hyundai Tucson (NX4) 2022-2026 Service Manual: Front Monitor
- Removal
1.Disconnct the negative (-) battery terminal.
2.Remove the front monitor lower cover (A).
3.Remove the front monitor lower cover after disconnecting the mood lamp connector (A).
4.Remove front monitor side cover (A) and (B).
5.Remove the front monitor assembly (A).
6.R ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Side Sill Molding
- Replacement
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent hand injuries.
1.Loosen the mounting screws, remove the side seal molding (A).
2.To install, rev ...
© 2023-2026 Copyright www.htucson4.com
