Hyundai Tucson Owners & Service Manuals

Hyundai Tucson: Smart Cruise Control Operation / Smart Cruise Control conditions not met

If the Driving Assist button, the +/- switch, or the button is pushed when Smart Cruise Control’s operating conditions are not met, the "Smart Cruise Control conditions not met" message appears on the instrument cluster, and an audible warning sounds.

In traffic situation

In traffic, your vehicle stops if the vehicle ahead of you stops. Also, if the vehicle ahead of you starts moving, your vehicle starts moving as well. In addition, after your vehicle has stopped and a certain amount of time has passed, the "Use switch or pedal to accelerate" message appears on the instrument cluster. Depress the accelerator pedal or push the +/- switch or button to start driving.

WARNING

While the message appears on the instrument cluster, if there is no vehicle in front or the vehicle is far away from you, and the +/– switch or button is pushed, Smart Cruise Control is automatically canceled and EPB is applied. If the accelerator pedal is depressed, EPB is not applied even though the function is canceled.

    Smart Cruise Control temporarily canceled
    Smart Cruise Control is temporarily canceled automatically when: Your vehicle speed is over 120 mph (190 km/h). Your vehicle is stopped for a certain period of time. Your accelerator ...

    Warning road conditions ahead
    The "Watch for surrounding vehicles" warning message may appear on the instrument cluster, and an audible warning sounds if the vehicle in front disappears when Smart Cruise Control is mai ...

    Other information:

    Hyundai Tucson (NX4) 2022-2025 Service Manual: Components and Components Location
    - Engine Room 1. Compressor2. Service port (Low pressure)3. A/C pressure transducer (APT)4. Service port (High pressure)5. Suction & Liquid pipe assembly6. Expansion valve cover - Interior 1. Auto defogging sensor2. Photo sensor3. PM sensor4. Heater & A/C control unit5. Heater ...

    Hyundai Tucson (NX4) 2022-2025 Service Manual: Antenna
    - Removal 1.Disconnect the negative (-) battery terminal. 2.Remove the roof trim.(Refer to Body - "Roof Trim Assembly") 3.Disconnect the antenna connector (A) and then remove the roof antenna after loosening mounting nut (B). - Installation 1.Install the integrated antenna and then conn ...

    © 2023-2025 Copyright www.htucson4.com