
1. Front seat heater switch
2. Rear seat heater switch

| Pin | Description | Pin | Description |
| 1 | IGN 1 | 17 | PDW switch |
| 2 | ILL (+) | 18 | PDW IND |
| 3 | 4WD lock swtich | 19 | - |
| 4 | Grip control swtich (+) | 20 | Heater LH |
| 5 | Grip control swtich (-) | 21 | Heater IND High_LH |
| 6 | Driver/Terrain mode symbol | 22 | Heater IND Mid_LH |
| 7 | ISG OFF IND | 23 | Heater IND Low_LH |
| 8 | ISG OFF switch | 24 | Heater RH |
| 9 | - | 25 | Heater IND High_RH |
| 10 | Steering wheel heater switch | 26 | Heater IND Mid_RH |
| 11 | Steering wheel heater IND | 27 | Heater IND Low_RH |
| 12 | SVM switch | 28 | - |
| 13 | - | 29 | DETENT |
| 14 | DBC switch | 30 | - |
| 15 | - | 31 | ILL (-) |
| 16 | LIN | 32 | Ground |
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent hand injuries.
• Take care not to bend or scratch the trim and panels.
1.Remove the console upper cover (A).

2.Press the lock pin, separate the connectors (A).

3.Remove the seat heater switch (A) after loosening mounting screws.

1.Install the front seat heater switch.
2.Install the console upper cover.
3.Connect the negative (-) battery terminal.
Seat Heater (Air Ventilation)
Air Ventilation SeatHyundai Tucson (NX4) 2022-2026 Service Manual: Accelerator Pedal
- Removal
1.Turn the ignition switch OFF and disconnect the battery (-) terminal.
2.Disconnect the accelerator position snesor connector (A).
3.Remove the upper mounting cap (B) and the loosen the mounting nut (C).
4.Remove the lower mounting cap (D) and the loosen the mounting bolt (E).Ti ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Electro Chromic Inside Rear View Mirror
Description and Operation
- Description
Electro Chromic Inside Rear View Mirror
The ECM (Electro Chromatic inside rear view Mirror) is intended dim the
reflecting light in the rear view mirror. The forward facing sensor
detects brightness of the surroundings, while the rearward looking
se ...