• When lifting a vehicle using a lift, be careful not to damage the lower parts of the vehicle (floor under cover, fuel filter, fuel tank, canister).(Refer to General Information - "Lift and Support Points")
1.Loosen the front wheel nuts slightly.Raise the vehicle, and make sure it is securely supported.
2.Remove the front wheel and tire.(Refer to Suspension System - "Wheel")
3.Loosen the stabilizer link mounting nut (A).
Tightening torque :98.1 - 117.7 N.m (10.0 - 12.0 kgf.m, 72.3 - 86.8 lb-ft)
• When loosening the nut, fix the outer hexagon of stabilizer bar link.
• Be careful not to damage the stabilizer link boots.


4.Remove the stabilizer bar after loosening the mounting bolts (A).
Tightening torque :49.0 - 63.7 N.m (5.0 - 6.5 kgf.m, 36.2 - 47.0 lb-ft)


1.Check the bushing for wear and deterioration.
2.Check the front stabilizer link ball joint for damage.
1.To install, reverse the removal procedures.
2.Check the alignment.(Refer to Suspension System - "Alingment")
Front Lower Arm G Bushing
Front Sub FrameHyundai Tucson (NX4) 2022-2026 Owner's Manual: Changing a Tire with TPMS
If you have a flat tire, the Low Tire
Pressure and Position telltales come
on. Have the flat tire repaired by an
authorized HYUNDAI dealer as soon as
possible or replace the flat tire with the
spare tire.
NOTICE
Do not use a puncture-repair kit not
approved by HYUNDAI. Tire sealant not ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Components and Components Location
- Component Location
[Fuel Tank]
1. Fuel tank2. Canister3. Vapor hose4. Canister Close Valve (CCV)5. Vent hose6. Fuel filler hose7. Fuel tank air filter8. Fuel Tank Pressure Sensor (FTPS)9. Fuel Level Sender (FLS)10. Fuel pump11. Fuel filter12. Fuel pressure regulator
[High Pressure Fuel Li ...