1.Disconnct the negative (-) battery terminal.
2.Remove the front monitor lower cover (A).

3.Remove the front monitor lower cover after disconnecting the mood lamp connector (A).

4.Remove front monitor side cover (A) and (B).


5.Remove the front monitor assembly (A).

6.Remove the front monitor assembly (A) after disconnecting monitor connectors.

7.Remove the front monitor cover (A) after loosening mounting screws.

8.Remove the front monitor cover after loosening mounting screws.

9.Loosen the mounting screws and remove the front monitor (A).

1.Install the front monitor.
2.Install the front monitor cover.
3.Install the front monitor assembly.
4.Install the front monitor side cover.
5.Install the front monitor lower cover.
6.Connect the negative (-) battery terminal.
• Make sure that the cables and connectors are plugged in properly.
• Check the AVN system for normal operation. (Navigation, Radio, USB, Bluetooth)
AVN Keyboard Assembly
Steering Wheel Remote Controller (SWRC)Hyundai Tucson (NX4) 2022-2026 Service Manual: Rear Oil Seal
- Replacement
• Be careful not to damage the parts located under the vehicle
(floor under cover, fuel filter, fuel tank and canister) when raising
the vehicle using the lift.(Refer to General Information - "Lift and
Support Points")
1.Remove the Automatic Transaxle A ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: In-car Sensor
- Description
The In-car air temperature sensor is built in the heater & A/C
control unit.The sensor consists of a thermistor that measures the
inside temperature. The signal decided by the resistance value that
changes in accordance with perceived inside temperature, is delivered to
...