Hyundai Tucson: Hydraulic System / Electronic Oil Pump (EOP)
1.Turn ignition switch OFF and disconnect the battery negative (-) terminal
2.Remove the engine room under cover.(Refer to Engine Mechanical System - "Engine Room Under Cover")
3.Disconnect the electronic oil pump connector (A).
4.Remove the electronic oil pump (A) after removing the bolts.
Tightenning torque :20.6 - 26.5 N.m (2.1 - 2.7 kgf.m, 15.2 - 19.5 lb-ft)
1.Install in the reverse order of removal.
• The existing O-rings (A), (B) must be replaced with a new one. (Do not reuse it.)
• After installing, check for leakage of coolant or fluid from hose connection during engine start.
2.Check the ATF level after refilling the automatic transaxle with fluid.(Refer to Automatic Transaxle System - "Automatic Transaxle Fluid (ATF)")
Description and Operation
- Description
• The hydraulic system consists of a valve body, an oil filter and an oil pump.
• The oil pump is powered by the engine. ATF passes through the oil filter and gets distributed ...
Valve Body
- Description
• The valve body is essential to automatic transaxle control and
consists of various valves used to control the oil feed from the oil
pump. Specifically, these valves consist o ...
Other information:
Hyundai Tucson (NX4) 2022-2026 Service Manual: Rear Wheel Guard
- Replacement
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent hand injuries.
1.Remove the rear tire.(Refer to Suspension System - "Wheel")
2.Loosen the mountin ...
Hyundai Tucson (NX4) 2022-2026 Owner's Manual: Drive Mode Integrated Control System
Type A
Type B
The drive mode can be selected
according to the driver’s preference or
road condition.
The system resets to NORMAL mode,
when the engine is restarted.
Information
If there is a problem with the instrument
cluster, the drive mode is in NORMAL
mode and may not change ...
