Hyundai Tucson: Warning and Indicator Lights / AUTO STOP indicator light. Turn signal indicator light
AUTO STOP indicator light
This indicator light illuminates:
When the engine enters the Idle Stop mode of ISG (Idle Stop and Go) system.
When the engine automatically starts, the AUTO STOP indicator on the cluster Illuminates to white.
For more information, refer to the "ISG (Idle Stop and Go) system" section in Chapter 6.
Information
When the ISG system automatically starts the engine, some warning lights (ABS, ESC, ESC OFF, MDPS or Parking brake warning light) may turn on for a few seconds because of a low battery voltage but not a system malfunction.
Turn signal indicator light
This indicator light blinks:
When you operate the turn signal lever.
If any of the following occur, there may be a malfunction with the turn signal system.
- The turn signal indicator light illuminates but does not blink.
- The turn signal indicator light blinks rapidly.
- The turn signal indicator light does not illuminate at all.
If any of these occur, have the vehicle inspected by an authorized HYUNDAI dealer.
Downhill Brake Control (DBC)
indicator light
This indicator light illuminates:
When the ignition switch is in the ON
position. The downhill brake control
indicator light illuminates for about 3
seconds and then goes off.
When yo ...
High beam indicator light. High Beam Assist indicator
light. Cruise indicator light
High beam indicator light
This indicator light illuminates:
When the headlights are on and turn
signal lever is moved to high beam
position.
When the turn signal lever is pulled
into ...
Other information:
Hyundai Tucson (NX4) 2022-2026 Owner's Manual: Smart Cruise Control Settings
Based on Drive Mode
Smart Cruise Control accelerates
differently based on the drive mode
selected from Drive Mode Integrated
Control system.
Information
For more information, refer to the
"Drive Mode Integrated Control
System" section in Chapter 6.
In some drive modes, Smart Cr ...
Hyundai Tucson (NX4) 2022-2026 Owner's Manual: Driver's Seat Belt – 3-point system
with emergency locking retractor
To fasten your seat belt:
Pull belt out of the retractor and insert
the metal tab 1 into the buckle 2. An
audible “click” sounds when the tab
locks into the buckle. Make sure the seat
belt is not twisted.
Place the lap belt 1 portion across your
hips and the shoulder belt 2 porti ...
