Hyundai Tucson: Rear Seat / Rear Seat Frame Assembly
1. Rear seat back frame assembly
2. Rear seat cushion frame assembly
1. Rear seat back frame assembly
2. Rear seat cushion frame assembly
• Put on gloves to prevent hand injuries.
• Take care not to bend or scratch the rear seat assembly.
1.Remove the rear seat assembly [LH].(Refer to Rear Seat - "Rear Seat Assembly")
2.Remove the rear back hinge cover [LH] (A).
3.Loosen the mounting screw, remove the rear back hinge cover [RH] (A).
4.Loosen the mounting screw, remove the rear seat shield inner cover (A).
5.Separate the rear seat folding cable (A).
6.Disconnect the seat heater connector (A).
7.Loosen the mounting bolts, separate the rear seat back assembly and rear seat cushion assembly.
Tightening torque :44.1 - 53.9 N.m (4.5 - 5.5 kgf.m , 32.5 - 39.8 lb-ft)
8.Remove the rear seat back cover.(Refer to Rear Seat - "Rear Seat Back Cover")
9.Remove the rear seat cushion cover.(Refer to Rear Seat - "Rear Seat Cushion Cover")
10.To install, reverse the removal procedure.
• Make sure that the connectors are connected completely.
1.Remove the rear seat assembly [RH].(Refer to Rear Seat - "Rear Seat Assembly")
2.Loosen the mounting screw, remove the rear back hinge cover [RH] (A).
3.Remove the rear back hinge cover [LH] (A).
4.Loosen the mounting screw, remove the rear seat shield outer cover (A).
5.Separate the rear seat folding cable (A).
6.Disconnect the seat heater connector (A).
7.Loosen the mounting bolts, separate the rear seat back assembly and rear seat cushion assembly.
Tightening torque :44.1 - 53.9 N.m (4.5 - 5.5 kgf.m , 32.5 - 39.8 lb-ft)
8.Remove the rear seat back cover.(Refer to Rear Seat - "Rear Seat Back Cover")
9.Remove the rear seat cushion cover.(Refer to Rear Seat - "Rear Seat Cushion Cover")
10.To install, reverse the removal procedure.
• Make sure that the connectors are connected completely.
Rear Seat Cushion Cover
- Component Location
1. Rear seat cushion cover [LH]2. Rear seat cushion cover [RH]
- Replacement
• Put on gloves to prevent hand injuries.
†...
Front Seat Belt
...
Other information:
Hyundai Tucson (NX4) 2022-2025 Service Manual: Electric EGR Control Valve
- Description
The Electric EGR Control Valve is installed in between the EGR cooler
and the exhaust line and is a solenoid valve. This valve controls EGR
(Exhaust Gas Recirculation) amount by the ECM's duty control signal
depending on engine load and the need of intake air.The Exhaust Gas
...
Hyundai Tucson (NX4) 2022-2025 Service Manual: Mic
- Inspection
1.Disconnect the negative (-) battery terminal.
2.Remove the overhead console.(Body Electrical System - "Overhead Console Lamp")
3.Check for continuity between terminal No. 1 and No. 2. If there is no continuity, replace the mic.
- Removal
1.Disconnect the negative (-) ...
