Hyundai Tucson Owners & Service Manuals

Hyundai Tucson: Power Liftgate Module / Power Liftgate Unit

- Components

- Circuit Diagram

- Removal

   

1)After replacing with a new power liftgate module, check for DTC code at all times.If DTC code B24B0 exists, perform power liftgate mode change.(Refer to Power Liftgate Module - "Troubleshooting")

2)After replacing with a new power liftgate module, perform the system initialization.(Refer to Power Liftgate Module - "Troubleshooting")

3)Before delivery to customer, operate the power liftgate to be sure that there is no warning sound.

1.Disconnect the negative (-) battery terminal.

2.Remove the luggage side trim LH.(Refer to Body - "Luggage Side Trim")

3.Disconnect power liftgate unit connectors (A).

4.Remove the power liftgate unit (A) after loosening mounting nuts.

- Installation

1.Install the power liftgate unit.

2.Install the luggage side trim LH.

3.Connect the negative (-) battery terminal.

- Inspection

Inspection of the Power Liftgate System

Refer to Power Liftgate System - "Troubleshooting"
    Troubleshooting
    - Failure Inspection Diagnosis with diagnostic tool 1.In the body electrical system, failure can be quickly diagnosed by using the vehicle diagnostic system (diagnostic tool).The diagnostic sy ...

    Power Liftgate Latch
    - Removal 1.Disconnect the negative (-) battery terminal. 2.Remove the liftlgate trim.(Refer to Body - "Liftgate Trim") 3.Disconnect the latch connector (A). 4. Remove the power liftgate lat ...

    Other information:

    Hyundai Tucson (NX4) 2022-2026 Service Manual: Balance Shaft Module
    - Removal and installation     • Be careful not to damage the parts located under the vehicle (floor under cover, fuel filter, fuel tank and canister) when raising the vehicle using the lift.(Refer to General Information - "Lift and Support Points") 1.Remove the oil pan. ...

    Hyundai Tucson (NX4) 2022-2026 Owner's Manual: Power-assist Brakes
    Your vehicle has power-assisted brakes that adjust automatically through normal usage. If the engine is not running or is turned off while driving, the power assist for the brakes does not work. You can still stop your vehicle by applying greater force to the brake pedal than typical. ...

    © 2023-2026 Copyright www.htucson4.com