Hyundai Tucson Owners & Service Manuals

Hyundai Tucson: Tire Pressure Monitoring System / Description and Operation

- Description TREAD Lamp

– Tire Under Inflation / Leak Warning.

1.Turn on condition

– When tire pressure is below allowed threshold

– When rapid leak is detected by the sensor.

– Indicates that tire needs to be re-inflated to placard pressure / repaired.

2.Turn off condition

– Under-inflation ; When tire pressure is above (warning threshold + hysteresis).

– Rapid Leak ; When tire pressure is above (leak warning threshold).

DTC Warning

1.Turn on condition

– When the system detects a fault that is external to the receiver/ sensor.

– When the system detects a receiver fault.

– When the system detects a sensor fault.

2.Turn off condition

– If the fault is considered as 'critical', then the lamp is held on throughout the current Ignition cycle (even if the DTC has been demoted). This is because it is important to bring the problem to the drivers attention. On the following Ignition cycle, the demotion conditions will be re-checked. If the demotion conditions occur, the lamp will be turned off. It will be held on until DTC demotion checking is completed.

– 'Non critical' faults are those that can occur temporarily e.g. vehicle battery under voltage. The lamp is therefore turned off when the DTC demotion condition occurs.

   

If the vehicle starts within 19 minutes after the replacement of the wheel of the stopped vehicle, the TPMS Malfunction Indicator on the instrument cluster illuminates.

– The above symptom is due to communication failure between the BCM and the replaced TPMS ID.

– This communication failure indicator turns off in 19 minutes after the vehicle stops through the BCM’s automatic learning process of TPMS ID.(When driving the vehicle after stopping for over 19 minutes, the indicator turns off automatically.)

System Fault

1.General Function

– The system monitors a number of inputs across time in order to determine that a fault exists.

– Faults are prioritized according to which has the most likely cause.

– Maximum fault store is equal to 15.

– Certain faults are not covered through DTC. The main ones are :

a.Sensor thermal shutdown (over 257°F / 125°C).

b.Ignition Line stuck ; requires observation of lamps at Ignition ON to diagnose.

    Tire Pressure Monitoring System
    ...

    Components and Components Location
    - Components Location 1. Receiver4. TPMS Sensor ...

    Other information:

    Hyundai Tucson (NX4) 2022-2026 Owner's Manual: Remotely controlling the vehicle
    To use the remote control feature with your Android smartphone, Bluetooth must be turned on. Remote control connection with digital key 1. Open the Hyundai Digital Key app on your smartphone and select your vehicle. 2. If your app allows, press the connect button and use the remote cont ...

    Hyundai Tucson (NX4) 2022-2026 Service Manual: Special Service Tools
    - Special Service Tools Tool(Number and Name)Illustration Use Ball joint remover09568-1S100 Removal of the tie rod end ball joint. Lower arm ball joint remover09568-4R100 Removal of the lower arm ball joint. Band installer0K495-C5000 Used for installing ear type boot band Band installer0949 ...

    © 2023-2026 Copyright www.htucson4.com