Information
Shifting conditions not met. Reduce speed, then shift
This message appears when the engine RPM is too high or when driving too fast to shift gears.
Decrease the engine RPM or slow down before shifting gears.
Press brake pedal to change gear
This message appears when the brake pedal is not depressed while shifting out of P (Park).
Depress the brake pedal and then shift the gear.
Shift to P after stopping
This message appears when the gear is shifted to P (Park) while the vehicle is moving.
Stop the vehicle before shifting to P (Park).
PARK engaged
Make sure that the vehicle is completely stopped before shifting to P (Park).
Press and hold the OK button on the steering wheel to stay in Neutral
This message appears when pressing the N (Neutral) button. If you want to stay in N (Neutral) after turning off the engine, press and hold the OK button on the steering wheel more than 1 second.
Vehicle will stay in (N). Change gear to cancel
This message appears when pressing the OK button on the steering wheel after the message, “Press and hold OK button to stay in Neutral when vehicle is Off” appears. The gear stays in N (Neutral) after turning off the engine.
NEUTRAL engaged
This message appears when the N (Neutral) position is engaged.
Gear already selected
This message appears when pressing the current shift button again.
Shift button held down
This message appears when the shift button is pressed continuously or the shift button does not properly operate. Clean the area around the gear shift button.
Have the vehicle inspected by an authorized HYUNDAI dealer.
Shifter system malfunction! Service immediately
This message appears when the transmission or the shift button does not properly operate in the P (Park) position. Immediately have the vehicle inspected by an authorized HYUNDAI dealer.
Check shift controls
This message appears when there is a malfunction with the transmission shift button.
Immediately have the vehicle inspected by an authorized HYUNDAI dealer.
Automatic Transmission
Operation
Paddle Shifter (Manual shift
mode)Hyundai Tucson (NX4) 2022-2026 Service Manual: Torque Converter Clutch Control Solenoid Valve (T/CON_VFS)
- Description
• Torque converter control solenoid valve (T/CON_VFS) is attached to the valve body.
• This variable force solenoid valve indirectly controls the hydraulic pressure inside the torque converter.
- Components Location
1. 28 Brake control solenoid valve (28/B_VFS)2. 4 ...
Hyundai Tucson (NX4) 2022-2026 Service Manual: Repair procedures
- Inspection
Front Door Lock Module Inspection
1.Remove the front door trim.(Refer to Body - "Front Door Trim")
2.Disconnect the connectors from the actuator.
3.Check actuator operation by connecting power and ground according to the table.PinDescription
DriverPanssenger
1-M2
2-M3
3COM- ...